page 9
10. Light Kit Assembly, 3- or 4-light Options.
Remove 3 screws from top of light kit
fitter.
Locate
BLUE
(or
BLACK
) and
WHITE
wires
in switch housing labeled FOR LIGHT KIT
CONNECTION. Remove and discard plastic
that holds these 2 wires together.
Next, locate
WHITE
and
BLACK
wires in
light kit fitter labeled FOR LIGHT.
Connect
WHITE
wire from light kit fitter
to
WHITE
wire from switch housing.
Connect
BLACK
wire from light kit fitter
to
BLUE
(or
BLACK
)
wire from switch
housing. Be sure molex connections snap
together securely.
Align holes in light kit fitter with holes in
switch housing. [
NOTE
: The gap on the
top edge of the light kit fitter must align
with reverse switch on the switch housing
for the proper fit.] Attach light kit fitter
with 3 screws that were previously
removed. Secure all 3 screws with a
Phillips screwdriver.
Loosen thumbscrews in light kit fitter.
Attach glass shades using thumbscrews.
Do NOT overtighten thumbscrews as glass
may crack or break.
Install bulbs included with light kit.
IMPORTANT
: When replacing bulbs,
please allow bulbs and glass shades to
cool down before touching them.
Please proceed to Section 11 on the
following page to complete installation.
motor housing
switch
housing
molex
connections
glass
shade
light kit fitter
pull chain
extension
thumb-
screws
pull chain
extension
thumbscrew
switch
housing
reverse
switch
molex
connections
bulb
light kit fitter
*For
Models C203
,
C204
,
C205
and
C206
,
follow instructions on this page.
