page 6
7. Canopy Assembly.
8. Blade Assembly.
motor housing
blade screw and washer
Time Saver:
Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm
up to blade (
sold separately
) and align holes.
Insert 3 blade attachment screws (along
with washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for the
remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (
save blade arm
screws and lock washers to secure blade arms
).
Align blade arm holes with motor screw
holes and attach blade arm with lock
washers and blade arm screws. Before
securing screws permanently, repeat
procedure with remaining blade arms.
Securely tighten all screws.
NOTE
: Tighten blade arm screws twice a
year.
plastic
motor
lock
blade arm
blade
blade attachment
screws and washers
lock washers
blade arm
screws
canopy
hanging bracket
screw
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed, and then
tighten both screws securely.
