Craftex CX800, User Manual

Page: 20 / 26

20
TO INSTALL THE NEW BELT:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Install the new belt on the pulleys and insert
the spindle through the outboard end into
the headstock.
Slide the bearing on to the spindle.
Thread the spanner nut onto the spindle.
Hold the faceplate with one hand and
tighten the spanner nut with the other hand
using the hex wrench provided. Secure the
spanner nut by tightening the set screws.
Reinstall the speed sensor on the
headstock and secure it using two screws.
Make sure the speed sensor is not touching
the pulley or the cord is not hanging around
the pulley.
Thread the shaft joint adaptor onto the
spindle and secure it by tightening the set
screws on it.
Align the key way with the key on the shaft
joint and reinstall the shaft joint onto the
shaft joint adaptor securing it by tightening
the set screws.
Install the hand wheel and secure it by
tightening the set screws.
Make sure the belt is installed on the right
grooves on the pulleys and tensioned
properly. Tighten the lock lever to lock the
motor in position and close the cabinet
door.
WARNING
Once the spanner nut is threaded onto
the spindle, rotate the spindle and make
sure the spanner nut is not over-
tightened. Over-tightening the spanner
nut will effect the rotation of the spindle.
WARNING
Make sure the switch is in the OFF
position and the cord is disconnected
from the power source before installing,
servicing and removing/replacing any
components on the machine. Failure to
do so may result serious personal
injuries.