Craftex CX800, User Manual

Page: 19 / 26

19
Remove the outboard spindle bearing as
shown in figure-22.
Figure-22 Removing the outboard spindle
bearing
Loosen the screws securing the speed
sensor, shown in figure-23 and bring the
sensor out and rest it on the headstock
opening.
Now, pull out the spindle lock pin and turn it
to 9 o’ clock position to unlock the spindle.
Figure-23 Uninstalling spindle speed sensor
Open the cabinet door and loosen the
motor lock lever. Use the motor height hand
wheel to raise the motor up. Retighten the
lock lever and remove the belt from the
motor pulley. See figure-24.
Figure-24 Removing the belt from motor
pulley
Remove the belt from the spindle pulley.
Now with one hand holding the spindle from
inside of the headstock, tap the spindle
using mallet from outboard side towards the
tailstock. See figure-25.
Figure-25 Removing the belt
Remove the belt as shown in figure-25 and
clean the outboard and inboard spindle
bearings. Apply a thick layer of grease on
the rollers of the bearings.