18
BELT REPLACEMENT
CX800 belt replacement is the procedure
which takes time and you need to be
patient while doing it.
To remove the belt, you need to remove the
hand wheel, shaft joint, shaft joint adaptor,
spanner nut, out-board spindle bearing, and
speed sensor.
TO REMOVE THE BELT:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Loosen the set screws securing the hand
wheel shown in figure-18 and remove the
hand wheel.
Figure-18 Securing set screws
Loosen the set screws securing the shaft
joint as shown in figure-19 and unthread the
shaft joint and remove it.
Figure-19 Removing the shaft joint
Loosen the set screws securing the shaft joint
adaptor. Unthread the shaft joint adaptor and
remove it. See figure-20.
Figure-20 Removing shaft joint adaptor
Loosen the set screws securing the spanner
nut and remove it. See figure-21.
Figure-21 Removing spanner nut
Summary of Contents for CX800
