Craftex CX509, User Manual

Page: 8 / 23

8
ASSEMBLY
It is recommended to assemble the stand
upside down.
Mount the top and bottom long brackets to
one of the legs as shown in figure-2 and
secure them using bolts and flange nuts
provided. Finger tighten for now.
Figure-2 Attaching top and bottom long
brackets to the stand leg
Attach the second leg to the top and bottom
long brackets and secure it with two bolts
and flange nuts. Finger tighten for now.
Attach the top and bottom short brackets to
the left and right side of the stand leg
assembly and secure them using bolts and
flange nuts provided. See figure-4. Finger
tighten for now.
Assemble the rest of the stand in the same
manner using nuts and bolts provided.
Figure-3 Stand assembly completed
Turn the stand upright and make sure all
the legs are evenly positioned. Now, tighten
all the nuts and bolts properly.
Get the help of a friend or use a fork truck
and lift the sander, align the mounting holes
and place the sander onto the stand.
Secure it using hex bolts, washers and nuts
provided.
Figure-4 Securing the sander to stand
Slide the hand wheel onto the shaft, making
sure the shaft pin inserts into the slot in the
hand wheel. Secure it using a cap screw
provided. See figure-5.
Figure-5 Installing the table height hand
wheel