Craftex CX509, User Manual

Page: 15 / 23

15
time until the feed belt does not slip on the
rollers anymore. See figure-12.
Once the feed belt is tensioned properly,
tighten the feed roller lock screws and feed
belt tensioning lock nuts.
FEED BELT
REPLACEMENT
The conveyor belt on the CX507 will get old
with use and will need a replacement.
TO REPLACE THE BELT:
Make sure the cord is disconnected from
the power source.
Raise the sanding drum to its highest
position using the table height adjustment
hand wheel.
Loosen the lock nuts on the feed belt
tensioning bolts on both sides of the table
and turn the bolts to release tension on the
feed belt.
Remove the cap screws shown in figure-13
and loosen the corresponding cap screws
on the inside edge.
Figure-15 Table cap screws
Get the help of an assistant and lift the
outside edge of the table, then slide the
feed belt off.
Clean any dust or debris on the rollers and
slide the new feed belt on.
Re-install and tighten the cap screws.
Tighten the feed belt adjustment bolts
equally and tension and track the feed belt
properly. See page-14.
WARNING!
Do not over-tension on the feed belt.
Over-tensioning the feed belt may cause
premature wear, and strain on the motor.
WARNING!
Make sure the machine’s power switch is
OFF and the cord is disconnected from
the power source when installing /
removing any part or servicing the
sander.