13
ASSEMBLY Continued
Rip Fence Assembly
The B2062L Tilting Arbor Saw is
equipped with a precision “T” Type,
Cam Lever Rip Fence
incorporating a Micro-Adjustment
and a Magnifying Cursor Lens.
Install the front rail to the leading
edge of the saw table using four pan-
head screws and lock washers
provided.
Using a combination square, set the
tail to 20mm. Use this along the
tabletop so that the front rail is 20mm
below it.
Tighten all screws.
Install the rear rail to the back edge
of the saw table with the four hex
screws and lock washers.
Use a combination square and set
the tail to 12mm. Use this along the
back surface of the table so the back
rail will be 12mm below the surface.
Attach the guide rail to the front rail
with six 16mm screws and lock
washers.
Rip Fence Adjusting
To adjust the fence so that it is level
with the saw table, rotate one or both
nylon screws to raise or lower the
fence.
The edge surfaces of the “T” rip
fence must be perpendicular to the
table surface. Use a square for
verification of this and adjust the
nylon screws accordingly.
To adjust the fence so that it is
parallel to the miter slot, remove the
fence and adjust one or both of the setscrews in the “T”.
Summary of Contents for B2062L
