Craftex B2062L, Owner'S Manual

Page: 12 / 30

12
ASSEMBLY Continued
Adjusting the Saw Table for Parallel
Should an adjustment be necessary, proceed as follows:
1. Refer to the Schematic Diagram on page 25.
2. Loosen the 10mm hex head cap screws, which fasten the cast-iron table
to the sheet metal cabinet.
3. Carefully, shift the table to a position where the saw blade is parallel to the
mitre gauge slots.
4. The saw blade must also be centered within the table insert opening.
5. Tighten the 10mm hex head cap screws.
Installation of Table Inserts
‰
Be sure that the table inserts and receptor is clean and free of dust and
wood chips.
‰
Lower the saw blade below the table surface.
‰
Place the standard insert into position
with the cut out on the blade side.
‰
Use a straight edge to be sure that the
top surface of the insert is flush with the
tabletop.
‰
To make any adjustments turn the insert
upside down and rotate the 6mm
adjusting screws to lower or raise the
insert.
‰
Be sure that the insert sits securely in its
position.
‰
Repeat this procedure with the dado insert.
‰
Raise the blade fully to be certain of no interference from the inserts.\