11
ASSEMBLY Continued
Hand Wheels
The blade elevation and blade tilt hand wheels
are installed at the factory. The handles for
these wheels are simply threaded into the
threaded holes provided.
Blade Alignment
Your B2062L Craftex Table Saw is
shipped from the factory with the
saw table adjusted so that the mitre
gauge slots are parallel to the saw
blade. However, shipping and rough
handling may have affected this
alignment. It is suggested that this
alignment be checked prior to
operating the saw.
A simple method of checking this
alignment is as follows;
Clamp a dowel to the mitre
gauge.
Pick out a saw tooth on the front of the blade and set the dowel so that it is
just touching the tooth. Mark the tooth with a felt marker.
Hand rotate the saw blade so that the marked saw tooth is now at the
back of the saw.
Gauge this tooth with miter gauge/dowel. If the tooth is in the same
position relative to the mitre gauge, the table is parallel to the saw blade.
In short, the miter slots
must
be parallel with the saw blade, therefore the
distance between the same saw tooth in the front or the back must be
equal.
Summary of Contents for B2062L
