Crafco EZ 500 Series II, Manual

Page: 42 / 136

EZ 500 Series II Melter Part Manual
Chapter 6 Maintenance Instructions
©2019 by Crafco, Inc. All Rights Reserved………………..…………………………………..….…Maintenance Instructions 6-4
6.12 Maintenance Chart
Hours
Possible Cause Procedure 8 50 250 500
Engine check oil level
Refer to the manufacturer’s
instructions for the engine
X
Other engine maintenance
Refer to the manufacture’s
operating and maintenance
instructions for the engine
Material Sensor Tube
Check for HTO fluid X
Add As needed
Heat Transfer Oil
Check X
Change X
Hydraulic Oil
Check X
Change X
Hydraulic Oil Filter Change X
Burner
Check burner box insulation X
Clean CAD cell
X
Check Electrodes X
Check Flame Retainer/Head X
Replace burner nozzle X
Wheel Bearings
Clean and re-pack using a good
grade of bearing grease Every 24,000 miles or two
years
Tongue Jack
Grease using a good grade of
bearing grease
Once a year
Compressor Refer to manufacturer’s instructions for the compressor
Material Tank
Scrape out built up material in
the material tank
Once a year or as needed
Material Sensor Guard
Scrape out built up material
around guard
X
For a list of parts required for maintenance see Table 6-3 General Maintenance Parts .
Table 6-1 Maintenance Chart