EZ 500 Series II Melter Part Manual
Chapter 6 Maintenance Instructions
©2019 by Crafco, Inc. All Rights Reserved………………..…………………………………..….…Maintenance Instructions 6-
10
6.19 Cleaning Material Tank and Sensor Area
The material tank needs to be cleaned every year or as needed for proper operation. As the
machine is used, material builds up around the tank walls and sensor guard. The built up material
prevents heat from getting to the fresh material and causes longer heat up times. The built up
material will also prevent the material temperature sensor from reading as accurately because it
becomes insulated from the fresh material. The coked material needs to be scraped or chipped
from the tank walls. The area between the sensor and sensor guard needs to be cleaned also for
proper temperature sensing. An air chisel with various sized blades usually works best to break up
the material and remove it from the walls. Once the walls and sensor guard areas are cleaned,
remove all the loose chunks from the tank, and vacuum out any smaller pieces.
6.20 Cleaning the Melter
We recommend using Orange-Sol industrial cleaner for cleaning the exterior of the machine. The
cleaner can be found at the following website;
https://www.orange-sol.com/industrial-formula/.
Summary of Contents for EZ 500 Series II
