24/7 Technical Support- Toll Free 1-877-472-8200
9
Concrete Polishing Solutions- G-290 Operator’s Manual
ATTENTION: This book has been prepared to provide information and suggestions
for Operators in their operation of the
G-290
grinder and polisher.
It is not intended that the suggestions in this booklet take precedence
over existing job-site safety rules and regulations, or OSHA regulations. However, a
thorough study of the following information should provide a better understanding
of safe operation and afford a greater margin of safety for people and machinery
on the job-site.
It must be recognized that this is a booklet of suggestions for the Operator’s
use. It is the responsibility of the owner to make personnel aware of all federal, state
and local rules and codes and to make certain operators are properly trained.
SAFETY MESSAGES
*
Always wear personal protective gear when operating the machine
without a vacuum system. Wear a properly fitting particle mask,
appropriate for this application, as specified by OSHA regulations.
*
Obey all safety signs and instructions when operating or maintaining
equipment.
*
Keep children and pets away from your grinder and polisher at all
times.
*
Always make sure to use the appropriate dust interceptor when
performing dry grinding operations.
*
When filling the tank with water, use only water in the water tank. Any
chemicals added may cause material breakdown, which may lead to
leakage. Leaks can get into electrical components, creating hazards
and causing potential injury.
*
The machine should only be used to grind and polish natural stone,
terrazzo, concrete or other CPS approved materials.
*
If the machine has been in a cold location, it should be placed in a
warm location for approximately 2 hours before use.
*
Keep the electrical parts of the machine dry. For best results, keep the
machine in a dry, warm, enclosed building.
