24/7 Technical Support- Toll Free 1-877-472-8200
8
Concrete Polishing Solutions- G-290 Operator’s Manual
The G-290 machines are designed to be used by a professional. The user is
expected to have a good knowledge and understanding of the user and
safety instructions before operating, inspecting, or adjusting the machine.
Following the safety instructions prevents damage to the operator and the
machine.
SAFETY MESSAGES
*
This machine should only be used or repaired by those who have received
proper training and have read the user manual
*
Secure the area around the worksite. Make sure any debris has been cleared.
Debris could be flung out by the machine and cause personal injury.
*
Always use protective equipment such as safety shoes, goggles, gloves,
breathing masking and ear protection, as required by OSHA.
*
The machine should be started with the grinding head down. All tools should
be touching the floor evenly.
*
During grinding, tools may become hot. Tilt the machine back and allow for
cooling before removing tools, using protective gloves.
*
Machine should only be used and moved on level surfaces. There is possible
risk of injury if the machine starts to roll.
*
Do not clean the machine using a high-pressure washer. Moisture could
penetrate and damage the machine’s drive system.
*
This machine is not suitable for picking up hazardous dust.
*
Never operate while under the influence of drugs, alcohol, or any substance
that could impair judgement.
*
Do not operate if machine is damaged
*
Do not use machine in areas where there is risk of fire or explosion. Put out
any smoking materials and other open flames before use.
*
Do not attempt to perform any maintenance or repairs while machine is
running.
*
Make sure to use 3-wire electrical system connected to electrical groud and
disconnect electrical supply before changing out or removing any tools. For
maximum protection against electrical shock, use a circuit that is proctected by
a gorund fault circuit interrupter.
*
If you must start machine while head assembly is in upright position, be certain
there are no plates mounted to the head.
*
Acceleration and vibration transmitted through the handlebars pending testing.
*
Sound level of this unit is pending testing.
*
Temperature of fixed wiring pending testing.
