![background image](http://html1.mh-extra.com/html/cpi/v2-colibri-36b-series/v2-colibri-36b-series_operating-instructions-manual_2675007033.webp)
o
peRaTion
BA_v2_colibri_ccTalk_EN_1-0
33
To save with the wide acceptance band:
8b
Set an additional DIL switch, S2.10, upwards to ON.
The acceptance band has been widened.
Only now set DIL switch S2.9 back downwards (to
OFF).
The system indicates successful saving with a single
actuation of the acceptance gate and an error at saving
with a double actuation (a brief clicking noise in each
case) if the acceptance band of the inserted coins and that of an already programmed coin
channel overlap or the generated measured values are too different and the tolerances
would be too high, for example.
To cancel the operation, first set the DIL switch of the corresponding coin channel
(S2.1-8, here: S2.3) as well as DIL switch S2.10 for the wide acceptance band
and then DIL switch S2.9 downwards (to OFF).
9
If necessary, set DIL switch S2.1‑8 again for normal operation
(cf. Chap. 7.2 Inhibiting coins/
activating narrow coin channel ..., p. 29)
10
If necessary, remount the coin validator in the machine.
11
Switch power off and on again.
12
Enable the taught coin channel (here: 11/27) via the control system and adapt sorting, if
necessary.
The coin validator will now accept the new coin type/token for payment.
7.3.2
... using ccTalk commands/machine service menu
If the coin validator is not write‑protected, you can teach coin channels via a ccTalk command
set to generate new acceptance bands
(cf. Chap. 10.2.1.5 ccTalk teach mode (not for ACMI version), p. 43)
.
This command set can be used to start and monitor the teach mode e.g. via a service menu.
The new acceptance bands are generated and saved by inserting ten coins/tokens of the new
type. After saving of the acceptance bands the coin validator will accept the new coin type/
token for payment.
Fur further information about teaching of coins/tokens via the service menu please refer to the
instruction manual for the machine.
If you have overwritten an already configured coin channel in teach mode,
you must adapt all the properties that are assigned to this channel (e.g.
coin ID, sorting, etc.) to the new coin/token (see the separate WinEMP
manual).
S2
S2