TECHNICAL FEATURES
Amps <10 amps
Watts
1000
Dimensions (W X D X H)
13” X 12” X 14.5”
Volts
110
Ship Wt. (lbs.)
30 lbs.
IMPORTANT SAFETY INFORMATION
PLEASE READ FIRST and FOLLOW THESE BASIC SAFEGUARDS WHEN USING THIS EQUIPMENT TO REDUCE RISK OF FIRE,
ELECTRICAL SHOCK AND/OR PERSONAL INJURY.
Plug equipment into GROUNDED outlet only. This outlet must be equipped with an approved G.F.I. (Ground Fault Interrupter)
Keep electrical cord away and clear of water.
DO NOT use the equipment if the supplied power cord is damaged or cracked in any way.
ALWAYS disconnect from the power source before servicing (unplug unit from wall).
Make sure that the brushes are placed on the machine securely before turning the machine on.
DO NOT insert anything other than glasses on the brushes or between the rotating/spinning brushes.
DO NOT use without the brushes in place and the air chimney in place.
DO NOT block the side ventilation openings in any way.
Long hair, jewelry, loose clothing CAN be caught in moving parts and pose an entrapment hazard.
USE THE MACHINE ONLY FOR THE PURPOSE IT WAS INTENDED — drying and polishing glassware.
USE ONLY CAMPUS PRODUCTS STEMSHINE PRO™ - GP5 replacement parts.
INSTALLATION INSTRUCTIONS
UN
P
ACKING THE MACHINE
The STEMSHINE PRO™ - GP5 is delivered packed in a cardboard box containing compressed polystyrene. Dispose of the packing
material according to the requirements of the local recycling laws. Verify the machine's integrity and in particular the electric cables.
If in doubt, ask a technician to check before proceeding with installation.
POSITIONING THE GLASS PO
LI
SHER
The STEMSHINE PRO™ - GP5 does not require anchoring - but must be level on whatever surface it is sitting on.
Ensure the STEMSHINE PRO™ - GP5 is not placed close to any taps and/or water connections.
ASSEMBLY — CHIMNEY and BRUSHES
Attached the hot air chimney onto the base of the STEMSHINE PRO™ - GP5 with the provided screw.
Each STEMSHINE PRO™ - GP5 is packaged with 5 brushes. There are 4 standard b 1 tapered brush.
Place each brush on top of
support (B)
and slide the brush down the support. Ensure that
slot (A)
is connected by slightly rotating the brush
in a clockwise direction. If the brush is not properly fixed on the support, it will not rotate once the machine is switched on.
To verify correct placement of the brushes, try to rotate them in a clockwise direction and then pull lightly upwards: if the brush does not
come off the support, placement is correct.
SLOT A
SUPPORT B