CPI 0102324500rR, Manual

Page: 44 / 124

CHPA S
ERIES
3-14 THIS DOCUMENT IS THE PROPERTY OF COMMUNICATIONS & POWER INDUSTRIES.
REPRODUCTION OR RELEASE WITHOUT EXPRESS PERMISSION IS STRICTLY PROHIBITED
D
OC
.01023245 R
EV
.R
Table 3-8. CHPA Commands
ASCII Byte Decimal Command Definition
@ 64 Transmit . This command turns the beam on.
A 65 Standby . This command turns the beam off.
B 66 RESET . This command is the equivalent of pushing the CANCEL button on the
front panel.
C 67 Set Attenuator . Provide the attenuator setting in the form NN.N. The interface
will accept leading spaces (ASCII 20 hex 32 dec).
(see note 1) (See Note 4)
D 68 Set RF O/P power in dBm . Provide the setting in the form NN.N. Leading
zeros may be replaced with spaces (ASCII 20 hex 32 dec).
(see note 1 )
E 69 Set RF O/P power in watts . Provide the setting in the form NNNN. Leading
zeros may be replaced with spaces (ASCII 20 hex 32 dec).
(see note 1 )
F 70 Set ALC RF O/P in dBm. This command activates the ALC mode and sets the
power requested. Provide the setting in the form NN.N.
G 71 Set ALC RF O/P in Watts. This command activates the ALC mode and sets
the power requested. Provide the setting in the form NNNN. Leading zeros may
be replaced with blanks.
H 72 Terminate ALC
I 73 Enable RF Inhibit
J 74 Clear RF Inhibit
K 75 Not used
L 76 Set Low RF Alarm Trip-point (Watts).
(see note 2)
M 77 Set High RF Alarm Trip-point (Watts).
(see note 2)
N 78 Set Low RF Fault Trip-point (Watts).
(see notes 2)
O 79 Set High RF Fault Trip-point (Watts).
(see note 2)
P 80 Not used
Q 81 Not used
V 86 Set Linearizer .
(see note 3)
To command the linearizer, send gain, phase, and
amplitude setting in the form NNN NNN NNN (each setting is separated by a
space) after V. To lock this setting in, see command X. Set Example: {AV123
211 012} where A is the address.
W 87 Query Linearizer .
(see note 3)
To query the linearizer, send W with no argument.
The response will be in the form NNN NNN NNN (gain, phase, amplitude).
X 88 Lock Linearizer Settings.
(see note 3)
Send this command to lock in (save to non-
volatile memory) linearizer settings. This command should be sent after the
desired linearizer settings have been achieved.