CPAT FLEX DRV3, User Manual

Page: 19 / 44

effigis.com
19
User Manual
3.2 DRV3 Parameters
When used in autonomous measurement mode (with the optional ARD4 module), all operating
parameters are set automatically by the ARD4.
NOTE
In autonomous measurement mode, access to menus is blocked to prevent
any changes to operating parameters. The menus are available as soon as you
exit this mode.
NOTE
After being set up in autonomous mode, the autonomous mode parameters
will stay active until the user provides new settings.
When used as find-and-fix tool, the parameters are set using the DRV3 menus. The following
sections describe how to set up the DRV3 using the unit’s own menus.
3.2.1 Accessing and Navigating the Setup Menus
Upon startup, the DRV3 defaults to measurement mode. In order to change the frequency,
enable or disable tagging, adjust the volume, change the units of measure or change any
other display setting, you must switch to setup mode.
To go to setup mode, press any of the four arrow buttons. Once you are in the settings menu,
you can move through the list of configurable elements by scrolling up and down with the
arrows.
To change the settings of an element, press the right arrow ( ) or the
Enter
button (
↵
)
when the cursor is over the desired element of the menu in the left column. This moves the
cursor to the right column, where you can then select a new value among the presets, or edit
a numerical value by highlighting the digit and then pressing the up or down arrow to obtain
the desired number. To save a new setting and return to the left column, press the left arrow
( ) or the
Enter
button (
↵
). When editing numerical values, press
Enter
button (
↵
) or
Esc
to return to the left column.
In order to save values and exit the settings menu, press the left arrow ( ) or the Enter
button ( ↵ ); to exit the menu without saving, press Esc .
Please refer to the following sections for details on configuring each element in the five
separate pages that constitute the settings menu.