PAGE 4 OF 7
STOP
DON’T RETURN TO STORE!
Step B - 1
Step B - 2
Step B - 3
Step B - 4
Step B - 5
support brace
Fig. B
Step B - 1:
Insert the seat arms (#6 and #7) into the
seat supports (#8 and #9) and fasten them
by using plastic joint covers (#15), bolts
(#19), washers (#23), and plastic nuts (#25).
NOTE:
(1) The label marked “back” on the left seat
arm (#7) should coincide with the label
marked “back” on the seat rear support
(#9) to ensure proper assembly.
(2) The clip holders attached to the seat rear
support (#9) should be positioned on the
inside of the swing. The open side of the
clip holder should be facing upwards.
Step B - 2:
Open the seat assembly (#10) and attach
its back to the seat arms (#6 and #7) by
using bolt (#20), washers (#24), plastic
washer (#27), and jam nut (#26). Do the
same procedure for both sides.
Step B - 3:
Make sure that the support brace on the
back of the seat assembly (#10) is fully
inserted into the clip holders on the seat
rear support (#9).
Step B - 4:
Attach the swing arm tubes (#11) to the
right and left seat arms (#6 and #7) by
using bolts (#18), washers (#23), and
plastic nuts (#25). Do the same procedure
for both sides.
Step B - 5:
Hook the suspension spring (#16) into
the top of both swing arm tubes (#11). Do
the same procedure for both sides.
