STOP
DON’T RETURN TO STORE!
PAGE 3 OF 7
Step A - 1
Step A - 2
Step A - 3
Step A - 4
Fig. A
Do not tighten bolts/nuts
after Step 1. Fasten
all bolts/nuts after Fig A.
ASSEMBLY (Note: For all nuts and bolts
fastening, always use a washer (#23 or #24)
between the tube and bolt or the tube and
nut.)
Step A - 1:
Insert the top cross beam w/adjustable teeth
(#1) into the upright supports (#2 and #3).
Fasten them by using bolts (#17), washers
(#23) and plastic nuts (#25). Repeat the
procedure for the other side. Do not tighten
bolts & plastic nuts yet.
Step A - 2:
Fasten the lateral cross braces (#4) to the
upright supports (#2 and #3) by using bolts
(#17), washers (#23) and plastic nuts (#25).
Repeat the procedure for the other side. Do
not tighten bolts & plastic nuts yet.
Step A - 3:
Fasten the rear cross brace (#5) to the rear
upright supports (#2) by using bolts (#17),
washers (#23) and plastic nuts (#25).
Tighten all of the bolts & plastic nuts now.
NOTE:
The label arrow mark on the rear cross
brace (#5) should be facing upwards.
Step A - 4:
Insert the leg caps (#14) to the rear and
front base feet.
