COUNTERFOG SDR-F05A+, User Manual

Page: 17 / 48

COUNTERFOG® SDR-F05A+ User Manual
COUNTERFOG® EBT de la UAH S.L. 17
o
Wait until pressure in the tank becomes that of atmosphere (no air
flows out at that time)
o
Connect the filling hose (2) to the inlet quick connection (3)
o
Open the filling valve ( Open 4 ) and check that valve 10 is closed .
o
Keep the filling hose (2) lower than the filling valve (4) and poor the
remaining liquid into a container using the filling hose. Dispose any
liquid according to the recommendations of the liquid manufacturer.
o
If the new disinfectant is not compatible with the previous one, then
the tank should be filled with water or an adequate solvent and
emptied again.
o
Disinfectant liquids usually need to be diluted in water (following the
instructions of their producer). You can fill your SDR-F05A+ with the
diluted solution or alternatively to fill it with the several components
according to the corresponding proportions.
o
Hold up the end of the filling hose (2) higher than the filling valve (4)
and use the funnel (1) to fill the tank (5) with liquid.
Remember to
keep open the filling valve (4) and the interlocking vent valve (6).
Always wear gloves and safety googles when filling the tank!
Do not overfill! This will damage the device.
o
Close the filling valve ( Close 4 ).
o
Close and lock the interlocking vent valve ( Close 6 ).
o
The residual liquid in the filling hose can be poured down in a container
lowering down its end and disconnect the inlet quick connection.
o
Disconnect the filling hose (2) from the Inlet quick connection (3).