Cotek S1500-112, User Manual

Page: 12 / 38

WARNING!
You may observe a spark when you make this
connection since current may flow to charge
capacitors in the power inverter.
Do not make this connection in the presence of
Flammable fumes. Explosion or fire may result.
11
WARNING!
Make sure all the DC connections are tight (torque to
9-10 ft-lbs, 11.7-13Nm). Loose connections will
overheat and could result in a potential hazard.
3-4-3. Before proceeding further, carefully check that cable you have just
connected does tie negative terminal of inverter to the negative output
power source.
CAUTION !
Reverse polarity connection will blow a fuse in inverter and
may permanently damage
the inverter.
Damage caused by reverse polarity connection is not
covered by warranty.
3-4-4. Connect the cable from the negative terminal of the inverter to the
negative terminal of the power source. Make a secure connection.
WARING !
You may observe a spark when you make this connection
since current may flow to charge capacitors in the power
inverter. Do not make this connection in the presence of
flammable fumes. Explosion or fire may result.
3-4-5. Set the power switch to the ON position. Check the meters and
indicators on the front panel of the inverter. The voltage bar graph
should indicate 11 to 14 volts (22 to 28V when 24V version is used)
depending on the voltage of the power source. If does not, check
your power source and the connections to inverter.
The other indicators should be off.