Coseng C211 C, Operation Manual

Page: 10 / 30

- 9 -
Fig.7
5) Move the tire so that the bead passes below the front section of the mounting head and
is brought up against the edge of the rear section of the mounting head. (Fig.7)
6) Keep the tire bead pressed down into the wheel rim channel with your hands. Then,
depress the reverse pedal to rotate the turntable clockwise. Continue this process
throughout the entire circumference of the wheel and tire.
7) Insert the inner tube (if there is one).
8) Repeat the steps above the mount the other side of the tire.
6-5 To Inflate The Tire
1) CAUTION: A burst tire can cause serious injury or even death to the operator. Always
make sure the wheel rim and the tire are of the same size. Check the condition of the
tire, and make sure it has no defects before beginning the inflation process. Keep your
hands and body as far away from the tire as possible. Inflate the tire with brief jets of air,
checking the air pressure frequently.
Never inflate a tire above and or below the air pressure recommended by the tire
manufacturer.
2) To inflate the tire, attach the air gauge nozzle to the tire valve stem with the locking lever
in the “UP” position. Check the condition of the tire, and make sure the nozzle is
pressed down completely over the threads of the valve stem.
3) When the air gauge nozzle is firmly in place, press the locking lever down to lock onto
the valve stem.
4) Remember to inflate the tire with brief jets of air, checking the air pressure frequently.
Once the proper air pressure has been reached, disconnect the nozzle from the valve
stem and screw a valve cap onto the stem. (Fig.8)
Fig. 8
NOTE
1) Failure to follow all warnings and instructions may lead to serious personal injury or
death to operator or bystander.
NEVER exceed 3.5 bar (50 psi) when seating beads or inflating tires.
2) If a higher tire inflation pressure is required, remove the wheel from the tire changer and