9
the tension control to the end of “+” side,(Under this circumstance the resistance cable stretch longest.) Put
the cable end of the resistance cable into the spring hook of Tension Control Wire as shown on drawing
A
of figure 3. Pull the resistance cable of Tension Control (28) up and force it into the gap of metal bracket of
Tension Control Wire (12) as shown on drawing
B
of figure 3. Connect the resistance cable with the Tension
Control Wire (12) completed as shown on drawing
C
of figure 3. If the resistance cable can not fit in the
metal bracket, please adjust the nut below the metal bracket. (See Figure 3)
C.
Insert the Handlebar Support (27) to the Main Frame (1) and secure it with four sets of M8X16 Bolts (59)
and
Ф
8 Are Washer (46). (See Figure 3)
4. Install the Handlebar and Computer
a. Attach the Handlebar (25) onto the Handlebar Support (27)
with two sets of M8*20 Bolts (41) and
Ф
8 arc Washers (46).
b. Connect the Computer cable (13), Hand pulse wire (54)
(If
have)
to the wire that comes from the Computer (26). Then fix
the Computer (26) on the top of the Handlebar Support (27).
(See Figure 4)
5. Install the Seat Post
a. Attach the Seat Cushion (20) onto the plate of Seat Post (21) with
three sets of Nylon Nuts (45) and
Ф
8
Flat Washers (48). (see Figure
5)
b. Insert the Seat Post (21) into the Bushing (22) and the main Frame
(1). Then adjust the Seat Post (21) to the desired hole for the
appropriate position and tighten the Round Knob (19) after
adjustment.
Note: when adjusting the height of seat post, the maximum
insert depth mark line cannot higher than the edge of bushing.
