BASE UNIT CONTROLS
1. TELEPHONE LINE
CONNECTION JACK
pg.5,28
2. POWER-IN
CONNECTION JACK
pg.5
3. TONE/PULSE
SELECT SWITCH
pg.6,28
4. BASE UNIT
ANTENNA
pg.5,10,28
6.PAGE BUTTON
5.IN USE/CHARGE
LED INDICATOR
pg.8,9
7.CHARGE
TERMINALS
I N U S E / C H A R G E
I N U S E / C H A R G E
2.4GHz
E
Problem Solving section
For your assistance, we have listed below a few common problems.
Phone does not work, check the following:
1.
BASE UNIT
is plugged into power source.
2.
HANDSET
is charged.
3. TONE/PULSE Select switch is in the right position.
4.TELEPHONE LINE CORD is plugged in the TELEPHONE JACK.
Range of phone limited, check the following:
1. ANTENNA on
BASE UNIT
is raised.
2.
BASE UNIT
is centrally located in your residence.
3.
BASE UNIT
is not located near appliances.
No dial tone, check the following:
1. TELEPHONE LINE CORD plugs are connected to the TELEPHONE JACK and
TELEPHONE LINE CONNECTION JACK.
2. BASE UNIT is plugged into a power source.
3. IF you had a power failure or had unplugged the BASE UNIT, replace the
HANDSET
on the BASE UNIT for 2 to 5 seconds to reset the system.
Received signal flutters or fades, check the following:
1. BATTERY PACK in
HANDSET
is fully charged.
2.
HANDSET
is not far from the BASE UNIT.
3. ANTENNA on
BASE UNIT
is raised.
Interference on reception, check the following:
1. Noise may be picked up from electrical products in the home or electrical storms.
Generally, this noise is a minor annoyance and should not be interpreted as a defect
in your system. (See Technical Information on page 30.)
2. Choose an alternate channel using the
button on the
HANDSET.
Long Distance "LDC" Indicator is not ON when receiving long distance call, check
the following:
1. Your local telephone company can provide the Area Code on an incoming long distance
call.
Excess static, check the following:
1. Check to see that the ANTENNA is not touching another metal object.
2. Raise or reposition the
BASE UNIT
ANTENNA.
If after pressing the button, you receive three "beeps" and no dial tone,
check the following:
1.
BASE UNIT
is plugged into power source.
2. If you had a power failure or had unplugged the
BASE UNIT
, replace the
HANDSET
on the
BASE UNIT
for 2 to 5 seconds to reset the system.
NOTE:
If none of the telephones in the house are working, disconnect one set at a time to verify
that none of the phones are causing the problem. If you still have a problem after doing
this, and your telephone still does not work, please contact your local phone company.
Problem Solving
28
/SCAN
DEL
