MOBILTEX® DATA LTD.
Calgary, Alberta
www.corTalk.com
TITLE:
RMU1 Installation and Configuration Guide
DOCUMENT NO.:
RMU1-MAN-001
SHEET:
31 of 53
REV:
1.14
A20100RMU10 Kit Contents Standard Screws Screws Removed Installed Kit
Figure 26 Banana Jack Test Point Kit A20100RMU10
The field installation process requires removal of the existing solid core ¼” screws present in the industry standard 3”
test station. The banana jack test point screws are then installed in the desired hole locations of the test station. A fiber
washer should be installed on the two surfaces that contact the plastic mounting surface of the test station. A ¼” nut is
used to secure the banana jack test point screw and two fiber washers to the test station. The remaining ¼” nut and lock
washer are used to secure the wiring termination. An optional test station shield (A20100RMU11) can be installed to
provide electrical isolation intended to prevent users from contacting the exposed termination screws of the test station.
5.9.3
Shield Installation with Banana Jack Test Point Kit
The test station shield (A20100RMU11) can be utilized with the banana jack test point kit (A20100RMU10) to provide
an electrically isolated enclosure with banana jack test lead access. The prior section details installation of the banana
jack test point kit. For this application banana plug access holes need to be drilled into the test station shield. The inside
surface of the shield has 16 recessed circular locations that act as pilot drill locations to provide access to the banana
jack test point screws. Drill a 3/16” (4.5mm) hole in each location that banana jack test point access is required. The
drilled shield is then installed on the test station securing the RMU1 using the Philips head screw.
Internal View c/w Drilled Holes External View c/w Drilled Holes
