ONE SD-LAN Wall
Mount Splitter Housing
(1LAN-SPLT-132-486C)
STANDARD RECOMMENDED PROCEDURE 000-000-AEN | ISSUE 1 | MARCH 2018 I
Page 2
2 Carton Contents |
•
Installation instruction
•
Wall Mount Splitter housing
•
Cable installation hardware
3 Tools and Materials Required |
3.1 Tools
•
Can wrench
•
Measuring tape
•
Appropriate tool kit with fiber stripping tools
3.2 Materials
•
Hardware for end-point cable installation
•
Mounting hardware appropriate for the surface upon which the housing will be installed
4 Mounting the Housing |
Step 1
Select the appropriate location for the housing to be installed
according to your installation plan. Choose a vertical surface
near approved ground but away from downspouts,
permanent water sprinklers, or other water sources. Ensure
the housing is easily accessible from the front to allow
technicians to connect customers as they subscribe for
service.
Figure 2
Step 2
Using the housing as a template (Figure 2), ensure the unit is
square and mark the locations for the mounting hardware.
Install appropriate anchors (not provided) to the surface to
which the housing will be attached. Use shims (not provided)
on uneven surfaces to ensure the housing is square and to
prevent warpage. Place the unit on the mounting surface
over previously determined mounting location.
Step 3
Insert the mounting hardware through the mounting ears and
tighten securely to the mounting surface/wall before installing
cable into the cabinet.
