11
620917311
5. Last are the auger housings (Items 74 and 75). They are dislodged by pulling upward. Check their orientation
and the fact that the longer tube is on the front side. When positioning the housings back in the dispenser,
the longer tube should be placed first so as to seat in the lower housing to set up the orientation (top and bot-
tom are marked on end of the tube tab at the top), otherwise the ice chute spout will not point towards the
front of the dispenser.
ARROW SHOWS CCW DIRECTION FOR INCREASING SPEED OF ICE AUGER MOTOR.
FIGURE 5. ICE AUGER MOTOR
SPEED CONTROL FOR ICE DELIVERY
The ice auger is a variable speed device. A potentiometer is used to control this speed. The potentiometer is lo-
cated in the electrical box which is below the counter.
The output shaft of the potentiometer protrudes through an opening on the bottom side of the electrical box. For
adjustment the output shaft (Items 62 and 59) is easily reached by removing the left side panel cover (item 42).
By turning the knob CCW (counterclockwise), you will increase the speed of the ice delivery. Please note that the
potentiometer position is upside down so the actual motion for increasing the speed if from left to right.
