Cornelius JetSpray JS7C, Operator'S Manual

Page: 6 / 20

Operator’s Manual
Publication Number: 620047630OPR - 2 - © 2009, IMI Cornelius Inc.
• Keep your machine in proper working condition and do not allow unauthorized modifications to
the machine.
Q
UALIFIED
S
ERVICE
P
ERSONNEL
CAUTION
- Only trained and certified electrical, plumbing and refrigeration technicians should service
this unit.
ALL WIRING AND PLUMBING MUST CONFORM TO NATIONAL AND LOCAL CODES.
S
AFETY
P
RECAUTIONS
This unit has been specifically designed to provide protection against personal injury. To ensure continued
protection observe the following:
IMPORTANT:
Disconnect power to the unit before servicing or cleaning.
ALWAYS:
be sure to keep area around the unit clean and free of clutter.
S
HIPPING
A
ND
S
TORAGE
CAUTION
- Before shipping, storing, or relocating the unit, syrup systems must be sanitized and all san-
itizing solution must be purged from the syrup systems. All liquids must be purged from the unit after san-
itizing. A freezing ambient environment will cause residual sanitizing solution or water remaining inside the
Unit to freeze resulting in damage to the internal components.
L
OCATION
Place the dispenser on a solid, level surface with not part of the unit extending beyond the edge of that surface.
P
OWER AND
W
ATER
Power
The JS7C requires a 120 Volt, 60Hz grounded receptacle for proper operation, grounding and safety.
NOTE: If the colors of the wires in the main leads of this unit do not correspond with the colored
markings identifying the terminals in your plug, proceed as follows:
The green and yellow wire must be connected to the terminal in the plug marked with one of the following
indicators.
1. The Letter E
2. Colored Green
3. The Earth Ground Symbol
4. Colored Green and Yellow
The blue wire must be connected to the terminal in the plug marked with the letter N or colored blue.
The brown wire must be connected to the terminal in the plug marked with the letter L or colored Orange.
Power Cord
If a power cord is damaged, do not attempt to replace it. Take your unit to your nearest authorized service center
for repair. A special tool is required to replace the cord.