Corghi PW IW 10, Manual

Page: 26 / 124

26 User manual
PW IW 6” 8” 10”
HoISTING/HaNDLING
In order to remove the machine from the pallet, lift it as shown in fig.2.
This hoisting point must be used whenever you need to change the installation position
of the machine. Do not attempt to move the machine until it has been disconnected from
the electricity and compressed air supply systems.
INSTaLLaTIoN CLEaraNCES
CAUTION
The place where the machine is to be installed must conform to applicable safety at
work regulations.
WARNING
The machine must not be installed in an open area.
Move the machine to the designated installation site, respecting the minimum distances
reported in fig.3.
Work environment conditions
- Relative humidity: 30÷95% without condensation
- Temperature 0°C - +55°C
CAUTION
The machine must not be operated in potentially explosive atmosphere.
INSTaLLaTIoN
ATTENTION
Install the unit at least 60 cm. from any heat source (fig.3).
PW IW ~ 6” 8” 10” base module
Level the machine using the adjustable feet (7 fig.4).
Hook-up to the electric mains (see the section on
“electricAl And pneumAtic hook-
up”).
PW IW ~ 6” 8” 10” additional module
Additional modules may be installed on the base module to obtain various machine
compositions.
To build up machines with several modules, connect the additional modules to the base
module in a number not exceeding the maximum permitted, which is 48 heads.