User and Maintenance Manual
Failsafe hydraulic brake ID 2000N
Model ID 2000N-116
Date: 2014/06/27
Revision: 1.1
www.coremo.it
Page
9
of
25
Photo 1
4.
Supply the brake and remove the safety hook (C62257) from the seat of the thruster which
protrudes from the cover (Photo 2). To prevent the safety hook from getting lost while the
brake is in operation, attach it to the side part of the caliper block (Photo 3) using the TCEI
M5x18 screw (C61372) as shown in assembly drawing A........ (use a CH BR 4).
Photo 2
Photo 3
5.
The brake is supplied with a bleed vent cod. Z50315 (Figure 2) as in Photo 4. To bleed air out of
the circuit, loosen the retaining nut of the fitting (Photo 5) and pull the tubular cap outward.
After bleeding off the air tighten the fitting again.
Photo 4
Photo 5
(Z50315)
