User and Maintenance Manual
Failsafe hydraulic brake ID 2000N
Model ID 2000N-116
Date: 2014/06/27
Revision: 1.1
www.coremo.it
Page
11
of
25
find the positions of the grub screws. To lock and/or unlock the adjuster, tighten and/or loosen
the grub screws using a CH BR 3 (Photo 8); when doing this, with the brake in operation or
during maintenance, the safety hook (C62257) must not be inserted in the seat of the thruster
(D71243) otherwise the operation cannot be carried out.
Warning
: The brake is supplied with the wear adjuster NOT locked.
Photo 8
8.
BEDDING-IN:
The initial braking torque may vary from 30% to 50% less than the rated value
until the lining has bedded into the disc.
a.
Before starting the bedding-in, ensure that the lining and disc surfaces are dry and clean.
b.
Slide the linings on the disc until the disc surface corresponds 100% to that of the
linings.
c.
The disc temperature during bedding -in must not be higher than 100°C.
d.
Clean the disc and lining surfaces so that there is no trace of dust or dirt.
e.
After bedding-in check that the disc has no trace of burns.
