Corecess R1-SW24L2B, User Manual

Page: 66 / 300

R1-SW24L2B User’s Manual
4-14
Starting the System
Start the Corecess R1-SW24L2B according to the following order after installation:
1. Check the followings once again before operating the Corecess R1-SW24L2B:
y
Make sure that cables are properly connected to each port.
y
Make sure that the power cord is properly connected.
2. Turn on the power of the console terminal and execute the terminal emulator program.
3. Turn on the Corecess R1-SW24L2B’s power by pressing the power switch (towards “I”) on
the front panel of the Corecess R1-SW24L2B.
4. Check to see if the cooling fans are operating.
5. If power is properly supplied to the Corecess R1-SW24L2B, the RUN LED turns on in green.
And you will see the following message on the console terminal:
U-Boot 1.1.1 (Wed Sep 28 10:33:51 KST 2005)
R-405 u-Boot Ver 1.0.5 (smile@hera)
CPU: IBM PowerPC 405GP Rev. E at 200 MHz (PLB=100, OPB=33, EBC=50 MHz)
PCI async ext clock used, internal PCI arbiter enabled
16 kB I-Cache 8 kB D-Cache
Board: Corecess R-405
I2C: ready
DRAM: 60 MB
FLASH: 512 kB
In: serial
Out: serial
Err: serial
PHYADD:not found.
OneNAND 32MB 2.65/3.3V 16-bit KFG5616U1M Samsung
BEDBUG:ready
Press CTRL-C to stop autoboot: 0
Loading from device onenand(0:0xf00000) to 0x1000000 ... 100%. complete.
## Booting image at 01000000 ...
Image Name: Linux-2.4.20-pre2-initrd
Created: 2005-10-27 7:20:03 UTC