Core Lighting StripPoint, User Manual

Page: 17 / 23

StripPoint User Manual rev.1_0 15
i
DMX Mode
The DMX channel mapping for each LED output on the fixture can be selected. A pixel consists of 4
LEDs: Red, Green. Blue, White. Pixel 1 is the right-hand end LED cluster on the batten, pixel 18 is the
left-hand end LED cluster.
DMX form
4 chan All 18 pixels are controlled by 4 DMX channels for Red, Green Blue, White.
No dimmer channel
5 chan All 18 pixels are controlled by 4 DMX channels for Red, Green Blue, White and the 5
th
channel controls the brightness (Dimmer channel)
8 chan Pixels 1 to 8 on RHS of fixture are controlled by channels 1 to 4
Pixels 9 to 18 on LHS of fixture are controlled by channels 5 to 8. No dimmer channel
9 chan Pixels 1 to 8 on RHS of fixture are controlled by channels 1 to 4
Pixels 9 to 18 on LHS of fixture are controlled by channels 5 to 8
Channel 9 controls the overall brightness (Dimmer channel)
72 chan Full pixel mapping such that each led in each pixel is controlled. No dimmer channel
A full mapping table is shown in Appendix 1 of this document.
Press and use the keys to select
“
CHANGE Settings
” then press
. to accept.
Use the keys to select
“
DMX Format
” and press
to select.
Use keys to toggle between 4, 5, 8, 9 or 72 Chan mode then press to save changes.
PWM Frequency Control
For HD TV work StripPoint is equipped with an option to adjust the PWM frequency of the LEDs to
prevent
‘beating’ with the TV scan frequency.
Press and use the keys to select
“
CHANGE Settings
” then press
. to accept.
Use the keys to select
“
PWM Freq
” and press
to select.
Then use the keys to select a from value from 244Hz to 1.9kHz. Press to save
changes
and the screen will revert to showing the ‘Function’ mode.
Beware that when using the higher frequencies the resolution of the colour intensity steps
is reduced, so the effect of colour changing can become less smooth
and more ‘steppy’.
Lamp Profile
The dimming curve can be selected to optimize for different applications
Press and use the keys to select
“
CHANGE Settings
” then press
. to accept.
Use the keys to select
“
Lamp Profile
” and press
to select.
Then use the keys to select
“Sq. Law” or “Linear” curve. Press
to save changes and
the screen will revert to showing the ‘Function’ mode.