IONIZER USER MANUAL
15
To start communicating at each plused DC bar ionizer, press START on Model
5711R remote controller. Press FUN button for select output parameters. LED
will display as below and all parameters can be adjustable by UP/DOWN. Once
user changed any parameter, press FUN to store value in memory and make
changed value operational.
1) Remote Controller
User can adjust parameters from remote controller.
Press START to adjust parameters
Press FUN to parameter modes and save value
Press NEXT to move next parameter mode
Press UP to increase selected parameter value
Press DOWN to decrease selected parameter value
User selectable value input from 0 to 9 for voltage and time
Parameter adjustment finished, press END for exit.
*If user did not press FUN, adjusted value will not store and
back to previous set value.
UP
DOWN
0-9
END
NEXT
FUN
START
7
Setup and Operation
Model 5711R
Remote Controller
2) Output On/Off
Press FUN and NEXT, output On/Off parameter will display.
On is factory default set for initial enable mode. Press UP/DOWN to change
individual pulsed DC bar ionizer on or off. Press FUN to store this set.
