Caution:
1.
Make sure that the power switch is "OFF" when changing batteries. If you install
the batteries when the power is "ON" , the machine may suddenly start.
2.
Please make sure you take out the batteries when you use the AC/DC Adaptor.
Damage may occur if you use the batteries and the adaptor at same time.
3.
Please use adaptor supplied DC 6V 1000mA AC/DC Adaptor.
Battery installation
1.
Make sure the power switch is off.
2.
Battery compartment is in the bottom of the sewing machine.
3.
Open the battery compartment cover and place 4 "AA" alkaline batteries
according to the polarity as indicated.
4.
Replace battery cover.
Adaptor application
1.
Please make sure that the power switch is "OFF".
2.
Insert the adaptor AC/DC into the AC/DC Jack on the back of the sewing machine.
Accessories
Battery and adaptor installation
Caution:
Remove batteries or disconnect adaptor before replacing the needle.
1.
Remove batteries and disconnect adaptor, then take the protective plate off.
2.
Turn handwheel until needle is in the highest position, loosen the needle
clamp screw and remove the old needle.
3.
Insert a new needle into the shaft with
the flat side toward the back of the
machine. Be sure to push the needle
all the way into the needle shaft
before tightening the needle clamp
screw.
4.
Replace the protection plate.
NB:
The needle supplied with this
machine is size 90/14.
Needle replacement
4
Bobbins
Needle Threader
Needle
Twin needle
Bobbin winding pin
Long spool pin
Foot control
AC/DC Adaptor
Battery installation
AC/DC Adaptor
• If the needle is incorrectly set the machine will
not sew.
• If the needle is too loose it will fall off when
you are sewing. Make sure the needle is fixed
in securely.