Stone Effect Fireplace
H790
Instructions for Use
Please read and retain these instructions for future reference
v001: 10/05/21
10/05/21
OPERATING INSTRUCTIONS
:
CONTROL PANEL:
Master Power Switch
Push this button to turn electric fireplace on. Two short beeps that increase in pitch sound when switched
on and three beeps that decrease in pitch sound when switched off
will be heard
. Once turne
d
on, the on
screen display shows
the
following:
When switched on, the heating level, set temperature and clock icon are displayed. The display disappear
after 60 second without any operation. Press any button to display again.
The default set temperature is 10°C. The heating icon will display and start heating when the room
temperature is less than the default setting (10°C). If the temperature is the default temperature it will
not heat.
The clock icon will be flashing because the time is not set yet. Please follow the steps in “Time Setting) to
set the time.
Temperature Buttons
Press to to start the temperature setting. Press button and to set the temperature.
a.
Press either button or to see the current set temperature on screen.
b.
Press button o or to adjust the temperature as desired. If the set temperature is higher than
the room temperature detected by appliance, the heating starts. The heating will not start if the set
temperature is lower than the room temperature.
NOTE: The temperature range including OFF, from 10°C to 30°C and ON. OFF for no heating, 10°C to 30°C
is the selectable temperatures and ON for continuous heating.
NOTE: Once the temperature is set higher than the room temperature, heating will start even it runs
under a weekly reset program.