Menvier40/100
Installation
Page 13
Step 2. Run Bus Cable
Please read “Cabling Requirements on page
8.
Step 3. Fit and Connect
the Keypad(s)
Siting the Keypad(s)
Do site the keypad(s):
Within the area protected by the alarm
system.
At a convenient height and location for
the user.
Out of sight of potential intruders.
Do NOT site the keypad(s):
Next to electronic equipment,
particularly computers, photocopiers or
other radio equipment, CAT 5 data lines
or industrial mains equipment.
Where the cable run from the control
unit will be longer than 100m (see
Cable Configuration and Length).
Note: Do not site two or more keypads
closer than one metre together, otherwise
their prox readers will interfere and be
unable to read tags.
Fitting Keypads
Use M4 25mm countersunk screws in at
least three fixing holes when mounting the
back of the keypad on the wall.
For Grade 3 systems drill out the hole for
the back tamper using a 7mm bit (see
Figuure 19).
Figure 19 Screw i-kp01 Back Box to Wall
Keypad Connection
Figure 20 shows the wiring connections at
the keypad and control unit.
Figure 20 Connecting a Keypad to the Bus
Keypad Addressing
The control unit assigns addresses to all
devices connected to the bus cable. You
must start this process off once all bus
devices are connected, during the initial
power up. See page 22 for instructions.
Backlight Control
You can control the appearance of the
keypad backlights and set/unset LEDs by
fitting links over the appropriate jumpers
on the keypad PCB (see Figure 8 on page 6
for the position of the jumpers).
The jumpers have the following functions:
ON
BRIGHT
BL
ABCD-ON
ON
BRIGHT
BL
ON
BRIGHT
BL
ABCD-ON
The set/unset LEDs are
disabled.
See Note.
ON
BRIGHT
BL
ABCD-ON
ON
BRIGHT
BL
ON
BRIGHT
BL
ABCD-ON
The set/unset LEDs
shows the setting
status of the system.
(Full set is the left
hand LED.) (see Note
overleaf)
ON
BRIGHT
BL
ABCD-ON
ON
BRIGHT
BL
ON
BRIGHT
BL
ABCD-ON
The key backlights are
disabled. They will
glow briefly for five
seconds when a user
presses a key.
ON
BRIGHT
BL
ABCD-ON
ON
BRIGHT
BL
ON
BRIGHT
BL
ABCD-ON
The key backlights
glow all the time at
normal intensity.
ON
BRIGHT
BL
ABCD-ON
ON
BRIGHT
BL
ON
BRIGHT
BL
ABCD-ON
The keypad backlights
glow all the time,
extra bright.
Note: To comply with PD6662:2010 the
set/unset LEDs should be disabled.