Capacity
Hole
spacing
cm / (in)
A
cm / (in)
B
cm / (in)
C
cm / (in)
D
cm / (in)
1000 W
24.8
(9-3/4)
11.6
(4-5/8)
46.8
(18-3/8)
32.7
(12-7/8)
11.6
(4-5/8)
1500 W
24.8
(9-3/4)
11.6
(4-5/8)
46.8
(18-3/8)
38.7
(15-1/4)
11.6
(4-5/8)
To install your heater at 25 cm (10 in) from the ground
(recommended height by CONVECTAIR), follow these directions:
1-
Free mounting brackets by pressing and pulling both locking
tabs on the back of the heater (Fig. B).
2-
Place the center of the mounting bracket's bottom holes (no.
2 Fig. B2) at the measure C (see Fig. B) from the ground and
make a mark.
3-
Check horizontality of the mounting bracket, then mark the
two top holes and pierce the 4 holes for fastening.
4-
Replace mounting bracket and fasten it appropriately with
screws (not included).
The installation must comply with applicable national and local
standards, and
CONVECTAIR
recommends that it be done by a
certified electrician.
This manual was prepared at the time of manufacture of the
device and in accordance with the standards applicable at the
time.
The company reserves the right to modify at any time the
Installation and User Guide to account for standards and their
evolution.
To avoid short circuits, please turn off the power
at the electrical panel prior to installation or repair.
If the power cable is damaged, it must be replaced by the
manufacturer, its after-sales service personnel or a similarly
qualified person to avoid any danger.
If the device has a glass front, do not use if the glass front is
damaged.
2.
INS
TALLA
TION AND
MOUNTING
MEASURES T
O
BE T
AKEN
