5
SOLO - Programming
Step 6: Program the SOLO
ENROL MASTER CARD
The Master Card is used to access all the programming functions of the SOLO.
Warning: When enrolling the Master Card, the controller will be reset to its
factory default condition and ALL USERS WILL BE PERMANENTLY REMOVED
FROM MEMORY. It is important, therefore, that you enrol the Master Card
before doing anything else.
Press and hold the S2 button, then press and hold the
S1 button at the same time. When the controller
beeps 3 times, release both buttons and the display will show
This indicates that the SOLO is now in ‘Enrol Master Card’ mode. Hold the Master
Card supplied against a reader until the controller beeps 3 times. The controller has
now enrolled the Master Card, ended the enrolment mode and is ready for normal
operation.
NOTE:
When pressing S2 and S1, if the display shows
t 1
, release both buttons
and wait 30 seconds for the display to clear, then try again.
ENROL USERS
Present the Master Card to a reader for approximately 5 seconds until the controller
beeps once and then three times. This signifies the ‘Enrol User’
mode. The controller displays a single dot in the centre of the display
Remove the Master Card and present a new user card until the controller beeps once,
indicating that it has enrolled the card.
Keep presenting new cards to enrol them until all the required user cards have been
enrolled (999 total). If presenting a card causes the controller to beep three times,
no more cards can be enrolled.
The controller will exit this mode after 30 seconds of inactivity, indicated by 3 beeps.
In the normal operating mode, pressing button S2 will display the number of the last
card used (e.g.
0 1 6
for user 16).
It is important to keep a record of who has which card and the relevant user
number, as it may be necessary to remove the user from the system in the
future. A table has been provided at the end of this manual to record this
information.
