Continuum V2532W, User Manual

Page: 34 / 48

A
www.rinnai.us
I N S TA L L E R ’ S I N S TA L L AT I O N I N S T R U C T I O N S
Remote Controls- General
The remote controls for the Continuum V2532W allow the customer to control the
functions of the water heater and to diagnose certain fault conditions.
The Main Controller model MC-45-4US is intended to be installed in the kitchen or
laundry area where the majority of the hot water is being used.
NOTE: The MC-45-4US has a temperature setpoint range of 96-140°F. This is the
only controller capable of temperature setpoints greater than 120°F.
The Bath Controller model BC-45-4US and Secondary Bath Controller model
BSC-45-4US are intended to be installed in a bath room close to a shower or
tub. Both of these controllers have temperature setpoint ranges of 96-120°F.
NOTE: Only one of each type of controller can be connected to one Continuum
V2532W water heater. (i.e. Installations with two MC-45-4US, two BC-45-4US,
or two BSC-45-4US controllers will not function properly.)
Before installing the remote controls, determine the most convenient location(s).
When deciding on the best location for the remote controls, please consider the
following items:
1) Place the controllers out of reach of small children.
2) Avoid locations where the controller(s) will become hot. (over the stove, near
the oven or a radiant heater.
3) Avoid direct sunlight. (The digital monitor can be difficult to read in direct
sunlight)
4) Avoid areas where the remote can be splashed with cooking water, oil or
sauce.
5) The remote control cables carry low voltage, 12VDC digital.
The controls can be wired in series or in parallel depending on which method is
desirable for the distances encountered from the Continuum V2532W to the controls.
Every installation is different
Continuum V2532W
Main Controller
Main Controller
Bath Controller
Bath Controller
Continuum V2532W
Series
Parallel
3 4 Model V2532W