Continuum V2532W, User Manual

Page: 35 / 48

A
www.rinnai.us
I N S TA L L E R ’ S I N S TA L L AT I O N I N S T R U C T I O N S
Remote Controls - Installation
1) Determine a suitable location for the
control.
2) Make three holes on the wall as
shown.
3) Run the cable between the control
and the Continuum V2532W or the
control and the other control.
4) Remove the face plate from the
remote control, using a screw driver.
5) Connect the cable to the remote control.
6) Mount the control to the wall using the holes drilled in step 2.
Note: If the cable cannot be run in the wall cavity, the plastic knockout should be
removed from the top or bottom of the control to allow flush mounting with
the wall
7) Disconnect the power from the Continuum V2532W.
8) Remove the cover of the Continuum V2532W .
9) Remove the plastic cover from the PCB and electrical connections.
DO NOT ATTEMPT TO CONNECT THE REMOTE CONTROLS WITH THE POWER ON,
THERE'S 120 VOLT POTENTIAL, NEXT TO THE REMOTE CONTROL CONNECTIONS
INSIDE THE UNIT.
DO NOT CONNECT THE REMOTE CONTROL TO THE 120VAC
TERMINALS PROVIDED FOR THE OPTIONAL SOLENOID DRAIN VALVES. All service
and wiring should be performed by a certified installer.
10) Thread the cable through the
access hole at the base of the unit
and connect the wires to the control
terminals labeled
“TERMINALS
FOR CONTROLS” on the right
hand side bottom of the PCB.
11) Secure the control cable using the
clamp provided.
12) Replace plastic cover over PCB and
then replace the cover of the
Continuum V2532W.
Model V2532W 3 5