24
W415-0380 / E / 08.31.12
Contact your dealer or the factory for questions concerning prices and policies on replacement parts. Normally
all parts can be ordered through your Authorized dealer / distributor.
FOR WARRANTY REPLACEMENT PARTS, A PHOTOCOPY OF THE
ORIGINAL INVOICE WILL BE REQUIRED TO HONOUR THE CLAIM.
When ordering replacement parts always give the following information:
•
Model & Serial Number of appliance
•
Installation date of appliance
• Part
number
•
Description of part
• Finish
* IDENTIFIES ITEMS WHICH ARE NOT ILLUSTRATED. FOR FURTHER INFORMATION, CONTACT YOUR
AUTHORIZED DEALER.
41.1
FAILURE TO POSITION THE PARTS
IN ACCORDANCE WITH THIS
MANUAL OR FAILURE TO USE ONLY
PARTS SPECIFICALLY APPROVED
WITH THIS APPLIANCE MAY
RESULT IN PROPERTY DAMAGE OR
PERSONAL INJURY.
!
WARNING
COMPONENTS
REF
PART NO.
DESCRIPTION
1*
W357-0001
PIEZO IGNITER
2
W662-0001
NATURAL GAS OXYGEN DEPLETION SENSOR SYSTEM
2
W662-0005
PROPANE GAS OXYGEN DEPLETION SENSOR SYSTEM
3*
W680-0004
THERMOPILE
4
W725-0030
NATURAL GAS VALVE
4
W725-0031
PROPANE GAS VALVE
5*
W385-0430
CONTINENTAL LOGO
6*
GD-660
STANDARD WALL SWITCH & 20FT OF WIRE
7
GL-633
LOG SET
8*
W361-0079
GLOWING EMBERS
9*
W550-0001
CHARCOAL EMBERS
10*
W550-0002
CHARCOAL LUMPS
11*
W361-0014
VERMICULITE
12
W135-0150
BACK - LOG #1
9.2 CARE OF PLATED PARTS
6.1
If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on
the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room
temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat
source.
10.0 REPLACEMENTS
