TD060100-0MA
1
7
3
Installation and Commissioning
Hardware Installation
For quick snap-mounting to 35 mm DIN rail, a reinforced DIN rail clip
is pre-attached to the back of the enclosure with two #4-40 pan-head
screws. If the clip is removed, the unit can be panel-mounted by
extending the top and bottom brackets which are shipped in retracted
position. The extended brackets can then anchor the unit to a wall or
other flat vertical surface with two #8 pan-head screws (also provided).
The left illustration of
Figure
7
shows a rear view of the unit with the
brackets in retracted position. The right illustration of
Figure
7
shows
the brackets extended and secured to the unit enclosure with the same
screws that were used in the retracted position.
Mounting
TS-35 DIN Rail Mounting
Panel Mounting
DIN rail clip
Panel mounting brackets
DIN rail clip support bracket
4-40 screws, flat-head (4)
4-40 screws, pan-head (2)
Figure
7
— Using the Panel-Mounting Brackets
The JC-MER-CXB is designed for mounting in an industrial enclosure
or wiring closet using either set of provided mounting hardware listed
below. The unit can also rest unsecured on a flat surface, if desired.
#8 screws, pan-head (2)