Contec FX-DS110-APL, User Manual, Page: 27 / 69

Setup
FX-DS110-APL
19
Table Top Installation
Use the rubber pads included with the unit.
To install on a table top, choose a sturdy, level surface with a
well-ventilated space (approx. 5 cm.) in all directions. Wireless
equipment has a larger sending and receiving range when it is in a
highly visible location. Choose a location where the sight lines
are as clear as possible.
Note!
Do not obstruct the ventilation slits. This can cause the
temperature inside the product to rise and can damage the
components inside.
Cable Installation
Connect the UTP connector to the UTP cable.
Notes!
･ When connecting this product to a personal computer or hub use
a twisted pair cable no more than 100m in length.
･
Use UTP cable having category 3, 4, or 5 specifications. (If using
a 10BASE-T power supply, use a UTP cable with category 5
specifications.)
･
When connecting with a personal computer (NIC) or hub up-link
port, use a UTP cross cable (TP-X).
･
When connecting with a hub (other than up-link port), use a UTP
straight cable.
POWER
WRX
WLINK
LINK
R X
PO WER
WRX
WLINK
LINK
RX
*1 Operates with the separately available cables TP-03 (3m), TP-05 (5m), TP-10 (10m), TP-20 (20m),
TP-50 (50m), TP-100 (100m)
*2 Operates with the separately available TP-X (30cm cross cable and attachment)
Note : The cable length between the unit and PC or hub should not exceed 100m.
POWER
WRX
WLINK
LINK
RX
PC (NIC)
HUB
UPLINK 8X 7X 6X 5X 4X 3X 2X 1X
Cross cable *2
Up-Link port
Normal port (not Up-Link port)
POWER
WRX
WLINK
LINK
RX
HUB
UPLINK 8X 7X 6X 5X 4X 3X 2X 1X
Straight cable *1
Figure 4.5. Cable Connection