Contec CNT-3208M-PE, User Manual

Page: 78 / 81

6. About Hardware
CNT-3208M-PE
71
Table 6.1. Specifications < 3 / 3 >
Item Specifications
Bus master
DMA channel 1 ch
Transfer bus width 32-Bit width
Transfer data length 8 PCI Words length (Max.)
Transfer rate 80MB / sec (Max.133MB / sec)
FIFO 1K-DWord
Scatter/Gather function 64MB
Interrupt factor Bus master event (7 ch)
Synchronization
Control output signal
Select the output signal by software when setting the synchronization master
board.
Control input signal
Select the synchronization factor by software when setting the synchronization
slave mode.
Connectable number of device 16 boards including the master board
Common
I/O address Occupies 2 locations, any 32-bytets and 64-byte boundary
Additional function
Filter function, count match pulse output, test pulse output,
disconnection alarm detection
Power consumption (Max.) 3.3VDC 1.8A
Operating condition
0 - 50°C, 10 - 90%RH (No condensation)
Bus specification
PCI Express Base Specification Rev. 1.0a x1
Dimension (mm) 169.33(L) x 110.18(H)
Connector used
CN1 : 96-pin half-pitch connector
PCR-E96LMD [mfd by HONDA TSUSHIN KOGYO CO., LTD.] or
equivalent to it
CN2, CN3 : PS-10PE-D4T1-B1 [JAE] or equivalent to it x 2
Weight 160g
Standard VCCI Class A, CE Marking (EMC Directive Class A, RoHS Directive)
*1 The frequency response at an extension of 50 m is about 10 MHz (depending on the wiring environment).
The frequency response at an extension of 100 m is about 5 MHz (depending on the wiring environment).
The frequency response at an extension of 150 m is about 1.5 MHz (depending on the wiring environment).
The frequency response at an extension of 300 m is about 1 MHz (depending on the wiring environment).
The frequency response at an extension of 600 m is about 500 KHz (depending on the wiring environment).
The frequency response at an extension of 1200 m is about 80 KHz (depending on the wiring environment)
*2 Please use the shielded cable with a length of less than 30m to meet “CE EMC Directive”.
*3 Please use the shielded cable to meet “CE EMC Directive”.
Board Dimensions
[mm]
169.33(L)
11
0.
18
(H
)
The standard outside dimension (L) is
the distance from the end of the board
to the outer surface of the slot cover.