1. Introduction
BX710 series User’s Manual
5
CAUTION
-
Do not use or store this product in a location exposed to high or low temperature that exceeds range
of specification or susceptible to rapid temperature changes.
Example:
- Exposure to direct sun
- In the vicinity of a heat source
-
Do not use this product in extremely humid or dusty locations. It is extremely dangerous to use this
product with its interior penetrated by water or any other fluid or conductive dust. If this product
must be used in such an environment, install it on a dust-proof control panel, for example.
-
Avoid using or storing this product in locations subject to shock or vibration that exceeds range of
specification.
-
Do not use this product in the vicinity of devices that generate strong magnetic force or noise. Such
products will cause this product to malfunction.
-
Do not use or store this product in the presence of chemicals.
-
To clean the BOX-PC, wipe it gently with a soft cloth dampened with either water or mild detergent.
Do not use chemicals or a volatile solvent, such as benzene or thinner, to prevent pealing or
discoloration of the paint.
-
This product’s case may become hot. To avoid being burned, do not touch that section while this
product is in operation or immediately after turning off the power. Avoid installation in a location
where people may come into contact with that section.
-
CONTEC does not provide any guarantee for the integrity of data on CF.
-
2.5 inches hard disk drive (HDD) of our company has not guaranteed use by continuation and
continuation power for 24 hours. When it is used by continuation operation and continuation power,
a life fails extremely.
-
Always disconnect the power cable from the receptacle before mounting or removing the expansion
board, or before connecting or disconnecting any connector.
-
To prevent corruption of files, always shutdown the OS before turning off this product.
-
CONTEC reserves the right to refuse to service a product modified by the user.
-
In the event of failure or abnormality (foul smells or excessive heat generation), unplug the power
cord immediately and contact your retailer.
-
To connect with peripherals, use a grounded, shielded cable.
-
The CF card connector doesn't support hot plug. The pulling out opening of the CF card cannot be
done in the state of power supply ON. Please neither pulling out opening of CF in the state of
power supply ON of this product nor come in contact with CF. This product may malfunction or
cause a failure.
- Component
Life:
(1) Battery--- The internal calendar clock and CMOS RAM are backed by a Lithium primary battery.
The backup time at a temperature of 25°C with the power disconnected is 10 years or
more.
(2) HDD ---The OS-installed model with Windows XP Profettional uses a HDD for the OS storage
area.
Estimated service life: 5 years or 15,000 power on hours, whichever comes first.
(3) CF, SSD---The OS-installed model with Windows Embedded Standard 2009 uses a CF card or a
SSD for the OS storage area.
Estimated failure rates: 100,000 rewrite cycles, 500,000 hours MTBF
* Replacement of expendables is handled as a repair (there will be a charge).
Summary of Contents for BX710 Series
