![background image](http://html1.mh-extra.com/html/conrad/jaxster-3d-hd/jaxster-3d-hd_manual_2654608004.webp)
3
3. General Information
Skyter 3D HD receiver enables receiving television and radio programs in satellite DVB-S/S2 and terrestrial DVB-T
standards. The device can be used together with an analogue or digital TV-set, audio amplifiers, home network
routers and other home devices. Skyter 3D HD is able to receive
“DVCrypt” system encoded channels.
4. Delivery contents
- DVB-S/S2 and DVB-T digital receiver Skyter 3D HD
1 pc
- Remote control
1 pc
- HDMI cable
1 pc
- User
’s setup Guide
1 pc
5. Description
5.1.
Front panel
Fig. 1 Front panel
1. Power button
2. Remote control sensor
3. Standby indicator - green is
”on”; red is “off” (standby)
4.
1,54” graphic OLED display
5. Channels up/down buttons
6.
“DVCrypt” card reader
7. USB 2.0 connection
„max 0,5Amp”
8. CI interface slot
5.2.
Rear panel
Fig. 2 Rear panel
1. Satellite LNB A & LNB B (satellite dish A & B input signals).
It is used to connect satellite dish / dishes to the receiver. (RF cable/cables are used). In case twin LNB
configuration is used, pls use two RF cables to connect A & B inputs with the satellite dish. In case single
LNB configuration is required, pls use one RF cable connected to LNB A input. LNB A input signal is
provided for both A & B inputs. Fully protected 14/18v LNB supply and DISEq commands are provided
separately for LNB A & LNB B inputs.
2. Terrestrial RF IN (Terrestrial RF antenna input).
It is used to receive RF signal from terrestrial antenna. 5v
of antenna supply is fully protected (0,1Amp current limit) and can be switched on in menu.
3. Terrestrial RF OUT (Terrestrial RF output).
It is used to connect RF terrestrial antenna to other devices:
analogue TV, etc.
4. SCART. It is used to connect a receiver to a TV-set with a SCART cable.
5. HDMI. It is used to connect a receiver to a TV-set or to a multichannel sound decoder with HDMI cable.
6. NET, RJ45 Ethernet port. It is used to connect a receiver to a LAN router with RJ45 Ethernet cable.
7. USB ports. The receiver has 2 USB 2.0 interface ports
„max power 1,0Amp each”. They are used for
various USB external devices connection (keyboards, HDD, etc.).
8. S/PDIF, coaxial output. It is used to connect a receiver to a multichannel sound decoder.
Summary of Contents for Jaxster 3D HD
Page 1: ......