Copyright © 2014 congatec AG
IGX1m02 21/134
3.8
Heatsink Installation Notes
Mounting backplate (included with heatsink):
Assembly Notes:
• Hold the heatsink with one hand so that it does not tilt while tightening the screws
• Slightly tighten each of the 4 screws so that they hold the heat sink in place. To do so, start with one screw and then slightly tighten the
other screws using a crossover pattern, all the while keep holding the heat sink straight with one hand.
•
Now you can fully tighten the screws. Once again start with one and then continue to tighten the other screws using a crossover pattern,
all the while keep holding the heat sink straight with one hand.
Caution
Insulating foil of backplate must NOT be removed, otherwise the conga-IGX may be damaged due to a possible short circuit.
Note
Recommended torque for heatsink screws: 0.6Nm
