Copyright
©
2014
congatec
AG
TS87m13
84/124
Feature
Options
Description
PWM Inverter Polarity
Normal
Inverted
Select PWM inverter polarity. Only visible if Backlight Inverter Type is set to PWM .
PWM Inverter Frequency (Hz)
200
- 40000
Set the PWM inverter frequency in Hz. Only visible if Backlight Inverter Type is set to PWM.
Backlight Setting
0%, 10%, 25%, 40%, 50%, 60%,
75%, 90%,
100%
Actual backlight value in percent of the maximum setting.
Inhibit Backlight
No
Permanent
Until End Of POST
Decide whether the backlight on signal should be activated when the panel is activated or whether it
should remain inhibited until the end of BIOS POST or permanently.
Invert Backlight Setting
No
Yes
Allow to invert backlight control values if required for the actual I2C type backlight hardware controller.
LVDS SSC
Disabled
, 0.5%, 1.0%, 1.5%,
2.0%, 2.5%
Configure LVDS spread spectrum clock modulation depth with center spreading and fixed modulation
frequency of 32.9kHz.
Digital Display Interface 1
(DDI1)
Auto Selection
isabled
HDMI/DVI
Select the output type of the digital display interface.
NOTE:
On conga-TS87 rev. A, the ‘Auto Selection’ option is not displayed and the default configuration
is ‘HDMI/DVI’.
Digital Display Interface 2
(DDI2)
Auto Selection
Disabled
Display Port
HDMI/DVI
Select the output type of the digital display interface.
NOTE:
On conga-TS87 rev. A, the ‘Auto Selection’ option is not displayed and the default configuration
is ‘HDMI/DVI’.
Digital Display Interface 3
(DDI3)
Auto Selection
Disabled
Display Port
HDMI/DVI
Select the output type of the digital display interface.
NOTE:
On conga-TS87 rev. A, the ‘Auto Selection’ option is not displayed and the default configuration
is ‘HDMI/DVI’.
►
GOP Configuration
submenu
Configure graphics output when using the UEFI Graphics Output Protocol (GOP) driver instead of legacy
video BIOS. Only visible if GOP driver is configured to be used in the ‘Video Option ROM Launch Policy’
setup node.